Description

Features

• A special collaboration with ViTrox to utilize their great IoT platform, V-ONE.
• Use a powerful microcontroller board, NodeMCU-ESP32S which is capable to run various IoT projects.
• It comes with a pin diagram card for NodeMCU-32S to make the hardware connection process easier.
• Step-by-step online manual guide to explore the V-ONE platform.
• Complete tutorial for 10 IoT projects.
• Suitable for makers, electronics enthusiasts, and students (tertiary and secondary education).

 

NodeMCU-ESP32S Specifications:

• Onboard ESP32-S module
• Onboard CH340, USB to UART converter
• USB port for power input, firmware programming, or UART debugging
• 2x19pin extension headers, breakout all the I/O pins of the module
• 2x keys, used as reset or user-defined
• WIFI module: ESP32-S
  • Processor: ESP32
• Built-in Flash: 32Mbit
• Antenna: Onboard PCB antenna
• Peripheral interface: UART/GPIO/ADC/DAC/SDIO/PWM/I2C/I2S
• WiFi protocol: IEEE 802.11 b/g/n
• Bluetooth: Bluetooth 4.2
• Frequency range: 2.4G ~ 2.5G (2400M ~ 2483.5M)
• WIFI mode: Station / SoftAP / SoftAP+Station
• Power supply: 5V
• Logic level: 3.3V
• Dimensions: 48.26mm x 25.4mm

Packing List

• 1 x NodeMCU-ESP32S WiFi Bluetooth BLE IoT Dev Board
• 1 x  USB Micro B Cable
• 1 x Breadboard
• 1 x DHT11 Sensor
• 1 x PIR Sensor
• 1 x Rain / Water Level Sensor
• 1 x MQ2 Smoke Sensor
• 1 x Moisture Sensor Module
• 2 x Infrared Sensor Module
• 1 x 1CH Active H/L 3V OctoCoupler Relay Module
• 1 x SG90 Micro Servo
• 1 x  300C 1.5-6VDC 7mm Shaft Motor
• 1 x  DIY 4 Blades 56mm Motor Propeller (Blue)
• 2 x Push Button
• LED
  • 1 x Red
  • 1 x Green
  • 1 x Yellow
• 3 x Resistor 0.25W 5% 220Ohm
• 20 x  Male to Female Jumper Wire (20cm)
• 20 x  Male to Male Jumper Wire (10cm)
• 1 x Philips Head Screwdriver (not shown in the picture)
• Card:
  • 1 x Pin Diagram Card for NodeMCU-ESP32S
  • 1 x Registration Card for FREE V-ONE Account